Kia Picanto: AVN System / AVN Remote Controller
Components and components location
1. Left Remote Control Switch (Audio + Hands free + Voice)
| 2. Right Remote Control Switch (Cruise+Trip Computer)
|
Schematic diagrams
[Audio + Bluetooth + Voice] |
[Trip (2 Button) + SEG LCD Cluster] |
[Trip (2 Button) + ACC + SLD] |
[Trip (4 Button) + DOT&TFT LCD Cluster] |
[Trip (4 Button) + ACC + SLD] |
Repair procedures
1. | Disconnect the negative (-) battery terminal. |
2. | Remove the steering wheel assembly.
(Refer to Steering System - "Steering Wheel")
|
3. | Remove the steering wheel remote control (A) after loosening the mounting screws. [LH]
[RH]
|
4. | Disconnect the steering wheel remote control connector (A). [LH]
[RH]
|
1. | Connect the steering wheel remote control connector. |
2. | Install the steering wheel remote control. |
3. | Install the steering wheel and driver airbag module. |
4. | Connect the negative (-) battery terminal. |
1. | Check for resistance between terminals in each switch position (LH).
[LH : Audio + Hands free + Voice]
Switch
|
Connector
terminal
|
Resistance
(±3%)
| SEEK Up
| 1-6
| 430 Ω
| SEEK Down
| 1.11 kΩ
| MODE
| 2.11 kΩ
| MUTE
| 3.11 kΩ
| Volume (+)
| 4.61 kΩ
| Volume (-)
| 6.81 kΩ
| Voice
| 10.71 kΩ
| END
| 18.91 kΩ
| SEND
| 40.91 kΩ
|
|
2. | Check for resistance between terminals in each switch position (RH).
[RH : Cruise + Trip]
Switch
|
Connector
terminal
|
Resistance
(±3%)
| Cancel
| 2-6
| 390 Ω
| SET -
| 610 Ω
| RES +
| 910 Ω
| Cruise ON/OFF
| 1.38 kΩ
| Cruise & Speed Limit ON/OFF
| 2.13 kΩ
| SCC (Following distance control)
| 3.63 kΩ
| Group
| 1-6
| 390 Ω
| Trip Up
| 610 Ω
| Trip Down
| 910 Ω
| ENTER
| 1.38 kΩ
|
|
Components and components location
Components
[Roof Antenna (Radio+GPS/GNSS+DAB+GSM)]
Repair procedures
Removal
Roof antenna
1.Disconnect the negative (-) battery termin ...
Schematic diagrams
Circuit Diagram
Description and operation
Description
The
multimedia jack on the console upper cover is for customers who like to
listen to external portab ...
Other information:
Description and operation
Description
Ignition timing is controlled by the electronic control ignition timing system.
The
standard reference ignition timing data for the engine operating
conditions are pre-programmed in the memory of the ECM (Engine Control
Module). The
engine opera ...
Repair procedures
Replacement
1.Remove the transaxle assembly.
(Refer to Manual Transaxle System - "Manual Transaxle")
2.Remove the flywheel.
(Refer to Cylinder Block Assembly - "Flywheel")
3.Remove the rear oil seal (A).
4.Using
the SST (09214-0310 ...