Other information:
Repair procedures
Inspection
1.Measure terminal - to - terminal resistance of blower resistor.
2.measured resistance is not within specification, the blower resistor must be replaced. (After removing the resistor)
Replacement
1.Disconnect the negative (-) battery terminal.
2.Remove the ...
Repair procedures
Replacement
1. Loosen the front door checker (A) mounting bolt.
Tightening torque :
19.6 - 29.4 N·m (2.0 - 3.0 kgf·m,14.5 - 21.7 lb·ft)
2. Detach the clips, and then remove the front door side weatherstrip (A).
3. Install in the reverse or ...