Kia Picanto: Automatic climate control system / Climate control air filter
A : Outside air
B : Recirculated air
C : Climate control air filter
D : Blower
E : Evaporator core
F : Heater core
The climate control air filter installed
behind the glove box filters the dust or
other pollutants that come into the vehicle
from the outside through the
heating and air conditioning system.
If dust or other pollutants accumulate
in the filter over a period of time, the
air flow from the air vents may decrease,
resulting in moisture accumulation
on the inside of the windshield
even when the outside (fresh) air position
is selected. If this happens, have
the climate control air filter replaced by
a professional workshop. Kia recommends
to visit an authorized Kia dealer/
service partner.
NOTICE
- Replace the filter according to the
Maintenance Schedule.
If the vehicle is being driven in severe
conditions such as dusty or
rough roads, more frequent air
conditioner filter inspections and
changes are required.
- When the air flow rate suddenly
decreases, have the system
checked by a professional workshop.
Kia recommends to visit an
authorized Kia dealer/service partner.
Ventilation
1. Set the mode to the position.
2. Set the air intake control to the
outside (fresh) air position.
3. Set the temperature control to the
desired position.
4. Set the fan speed co ...
Each symbols and specification on air
conditioning refrigerant label means as
below ;
1. Classification of refrigerant
2. Amount of refrigerant
3. Classification of Compressor lubricant
You ...
Other information:
Depress the brake pedal.
Depress the clutch pedal if equipped
with a manual transaxle.
Shift into N (Neutral) if equipped with
an automatic transaxle.
Press the O/CANCEL switch located
on the steering wheel.
Decrease the vehicle speed lower
than the memory speed by 20 km/h
...
Components and components location
Component Location
1. Front seat belt buckle
Repair procedures
Replacement
1.Remove the front seat assembly.
(Refer to Front Seat - "Front Seat Assembly")
2.Disconnect the front seat belt wiring mounting clips (A). ...