Kia Picanto: Button Engine Start System / ESCL(Electronic Steering Column Lock)

Kia Picanto JA 2017-2024 Service & Repair Manual / Body Electrical System / Button Engine Start System / ESCL(Electronic Steering Column Lock)

Components and components location

Component

Repair procedures

Removal

1.	Disconnect the negative(-) battery terminal.

2.	Remove the crash pad lower panel. (Refer to Body - "Crash Pad Lower Panel")

3.	Remove the steering column upper and lower shrouds. (Refer to Body - "Steering Column Shroud Panel")

4.	Disconnect the electronic steering column lock connector (A).

5.	Remove the electronic steering column lock (A). (Refer to Steering System - "Steering Column and Shaft")

Installation

Install the electronic steering column lock.

•	Do not reuse the shear bolts.

•	When installing the new shear bolts to the electronic steering column lock, tighten the shear bolts until its head is cut off.

Tightening torque :

7.0 - 13.0 N·m (0.7 - 1.3 kgf·m, 5.0 - 9.4 lb·ft)

2.	Install the steering column.

3.	Install the crash pad lower panel.

Start/Stop Button

Components and components location Component Repair procedures Removal 1.Disconnect the negative (-) battery terminal. 2.Remove the crash pad lower panel. (Refer to Bod ...

Electro Chromic Inside Rear View Mirror

Components and components location Components Description and operation Description The ECM (Electro Chromatic inside rear view Mirror) is one that automatically dims to prot ...

Other information:

Kia Picanto JA 2017-2024 Owner's Manual: Notes on the safe use of the Tire Mobility Kit

Park your car at the side of the road so that you can work with the TMK away from moving traffic. Place your warning triangle in a prominent place to make passing vehicles aware of your location. To be sure your vehicle will not move, even when you're on fairly level ground ...

Kia Picanto JA 2017-2024 Service & Repair Manual: Auto Light Sensor

Repair procedures Inspection Check if the auto light control operates like a timing chart shown below. Tail lamp output and head lamp (Low) output is controlled based on the auto light sensor's input (illumination intensity) when the Auto Light Switch in Multi-Function Switch is turned ...