Kia Picanto: Features of your vehicle / Fuel filler lid

Kia Picanto JA 2017-2024 Owner's Manual / Features of your vehicle / Fuel filler lid

Opening the fuel filler lid

The fuel-filler lid must be opened from inside the vehicle by pulling up on the fuel-filler lid opener located on the front floor area on the driver’s seat.

NOTICE

If the fuel filler lid will not open because ice has formed around it, tap lightly or push on the lid to break the ice and release the lid. Do not pry on the lid. If necessary, spray around the lid with an approved de-icer fluid (do not use radiator anti-freeze) or move the vehicle to a warm place and allow the ice to melt.

1. Stop the engine.

2. To open the fuel filler lid, pull up the fuel filler lid opener.

3. Pull the fuel filler lid (1) out to fully open.

4. To remove the cap, turn the fuel tank cap (2) counterclockwise.

5. Refuel as needed.

Closing the fuel filler lid

1. To install the cap, turn it clockwise until it “clicks”. This indicates that the cap is securely tightened.

2. Close the fuel filler lid and push it lightly and make sure that it is securely closed.

Hood
Opening the hood 1. Pull the release lever to unlatch the hood. The hood should pop open slightly. WARNING Open the hood after turning off the engine on a flat surface, shifting the shift ...

Gasoline reservoir in the engine room
If your vehicle is FFV (Flex fuel vehicle), it needs to be checked and the reservoir should be filled in with the gasoline for cold start when the outside temperature is low (below 20°C). ...

Other information:

Kia Picanto JA 2017-2024 Service & Repair Manual: Power Window Motor


Components and components location Components [Standard Window Motor] [Safety Window Motor] Repair procedures Inspection    • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tool ...

Kia Picanto JA 2017-2024 Owner's Manual: Non-operational conditions of rear parking assist system


The rear parking assist system may not operate properly when: 1. Moisture is frozen to the sensor. (It will operate normally when the moisture has been cleared.) 2. The sensor is covered with foreign matter, such as snow or water, or the sensor cover is blocked. (It will operate normal ...

Copyright © www.kpicanto.com 2017-2024