The speedometer indicates the speed of the vehicle and is calibrated in miles per hour (mph) and/or kilometers per hour (km/h).
The tachometer indicates the approximate number of engine revolutions per minute (rpm).
Use the tachometer to select the correct shift points and to prevent lugging and/or over-revving the engine.
CAUTION
Do not operate the engine within the tachometer's RED ZONE. This may cause severe engine damage.
Engine Coolant Temperature Gauge
This gauge indicates the temperature of the engine coolant when the ignition switch or Engine Start/Stop button is ON.
CAUTION
If the gauge pointer moves beyond the normal range area toward the “130 or H” position, it indicates overheating that may damage the engine.
Do not continue driving with an overheated engine. If your vehicle overheats, refer to “If the engine overheats” on page 7-07.
WARNING
Never remove the radiator cap when the engine is hot. The engine coolant is under pressure and could severely burn. Wait until the engine is cool before adding coolant to the reservoir.
This gauge indicates the approximate amount of fuel remaining in the fuel tank.
NOTICE
WARNING
Fuel Gauge
Running out of fuel can expose vehicle occupants to danger. You must stop and obtain additional fuel as soon as possible after the warning light comes on or when the gauge indicator comes close to the “0 or E (Empty)” level.
CAUTION
Avoid driving with an extremely low fuel level. Running out of fuel could cause the engine to misfire damaging the catalytic converter.
The odometer Indicates the total distance that the vehicle has been driven and should be used to determine when periodic maintenance should be performed.
- Odometer range : 0 ~ 1,599,999 km or 999,999 miles.
This gauge indicates the current outside air temperatures by 1°C (1°F).
- Temperature range :
- 40°C ~ 60°C (- 40°F ~ 140°F)
The outside temperature on the display may not change immediately like a general thermometer to prevent the driver from being inattentive.
To change the temperature unit (from °C to °F or from °F to °C)
• Type A Cluster
Change the trip modes to Distance To Empty mode and then press and hold the RESET button for 5 seconds and more.
• Type B Cluster
The temperature unit can be changed by using the “User Settings” mode of the LCD Windows.
❈ For more details, refer to “LCD Windows” on page 4-50.