Kia Picanto: Steering wheel / Heated Steering wheel

Kia Picanto JA 2017-2025 Service & Repair Manual / Steering System / Steering wheel / Heated Steering wheel

Description and operation

Description

The heated steering wheel system improves the thermal comfort of the driver by heating the steering wheel when manually selected.

1.	Heated control unit

2.	Heated pad

Specifications

Item	Specification
Voltage	13.5 V ± 0.1V, 80W±10%
Heated pad resistance	1.85 ± 0.2 Ω (at 22°C ±1°C)
NTC resistance	10.0 kΩ ± 3% (at 23 - 27°C)

Schematic diagrams

System Circuit Diagram

Harness Connector

Terminal Function

Housing	Pin	Function	Wire color
Pad	A	GND	Black
	B	HEATER	Yellow
	C	NTC+	Black / Red
	D	NTC¯	Black

Repair procedures

Inspection

1.	Measure a resistance of NTC and Heated pad. NTC resistance (Black / Red, Black) : 10.0 kΩ ± 3% (at 23 - 27°C) Heated pad resistance (Yellow) : 1.85 ± 0.2 Ω (at 22°C ±1°C)

Measure a temperature.

–	The temperature of wheel surface grip must rise from -20°C to 20°C within 6 minute

–	The temperature of wheel surface grip must keep 38°C after 25 minute

Steering wheel

Components and components location Components 1. Bezel 2. Lower cover 3. Steering wheel 4. Remote switch 5. Wiring 6. Heated steering control unit Repair procedures Removal 1 ...

Motor Driven Power Steering

Description and operation Description MDPS (Motor Driven Power Steering) system uses an electric motor to assist the steering force and it is an engine operation independent steering syst ...

Other information:

Kia Picanto JA 2017-2025 Service & Repair Manual: Fuel Delivery System

Components and components location Components Location Fuel Tank & Filler-Neck Assembly 1. Fuel Tank 2. Fuel Pump 3 Fuel Filter 4. Fuel Pressure Regulator 5. Fuel Pump Plate Cover 6. Canister 7. Fuel Level Sender 8. Fuel Filler Hose 9. Leveling Hose 10. Vaper Hose (Canister → ...

Kia Picanto JA 2017-2025 Owner's Manual: Side repeater lamp (bulb type) bulb Replacement

1. Remove the lamp assembly from the vehicle by prying the lens and pulling the assembly out. 2. Disconnect the bulb electrical connector. 3. Separate the socket and the lens parts by turning the socket counterclockwise until the tabs on the socket align with the slots on the lens pa ...