The heated washer nozzle function defreeze the washer nozzles in freezing weather.
The heated washer nozzle will turn on and off automatically when the ignition switch is in ON or when the engine is running in following conditions:
- Turns ON when the outside temperature
is below 5°C, and OFF when it is
over 10°C.
- The washer fluid defreezing speed
may be slower when the ignition is in
ON, than compared to when the engine
is running.
- When the ignition is in ON, after
20 minutes of operation, the system
will turn off automatically to prevent
possible battery discharge.
- After the engine is running, the
washer fluid will defrost after
5 to 10 minutes.
- If the engine has been started within
the operating temperature, the heated
nozzle remains ON even after
20 minutes.
NOTICE
In below conditions, the heated washer nozzle may not function properly.
- The washer fluids in the washer
reservoir is frozen.
- Outside temperature sensor is
malfunctioning.
In the O (Off) position, pull the lever gently toward you to spray washer fluid on the windshield and to run the wipers 1-3 cycles. Use this function when the windshield is dirty.
The rear window wiper and washer switch is located at the end of the wiper and washer switch lever. Turn the switch to desired position to operate the rear wiper and washer.
Repair procedures Inspection • Wrap tin foil around the end of the voltmeter test lead to prevent damaging the heater line. Apply pressure on the tin foil with hand and move the tin foil along the grid line to check for open circuits.
Specifications Specification Air conditioner Item Specification Compressor Type 5VSe09(Variable Dispacement Swashplate) 5VS09 Oil type & Capacity FD46XG(PAG) 100±10g Pulley type POLY V RIBBED BEIT 6PK Displacement 90cc/rev Condenser Heat rejection 9,890 -3% kcal/h