Kia Picanto: Features of your vehicle / Rear parking assist system
The rear parking assist system assists the driver during backward movement of the vehicle by chiming if any object is sensed within a distance of 120 cm (47 in.) behind the vehicle.
This system is a supplemental system and it is not intended to nor does it replace the need for extreme care and attention of the driver. The sensing range and objects detectable by the back sensors (➀) are limited. Whenever backing-up, pay as much attention to what is behind you as you would in a vehicle without a rear parking assist system.
WARNING
The rear parking assist system is a supplementary function only. The operation of the rear parking assist system can be affected by several factors (including environmental conditions). It is the responsibility of the driver to always check the area behind the vehicle before and while backing up.
- Operation of the rear parking assist system
- Non-operational conditions of rear parking assist system
- Rear parking assist system precautions
- Self-diagnosis
Indicator Lights
Electronic Stability. Control (ESC) Indicator
Light
This indicator light illuminates:
Once you set the ignition switch or
Engine Start/Stop Button to the ON
position.
- It illuminate ...
Operation of the rear parking
assist system
Operating condition
This system will activate when backing
up with the ignition switch ON.
If the vehicle is moving at a speed
over 5 km/h (3 mph), the system
may not be activated corr ...
Other information:
Kia Picanto JA 2017-2025 Owner's Manual: Map lamp bulb replacement
1. Using a flat-blade screwdriver, gently pry the lens cover from lamp housing. 2. Remove the socket from the assembly by turning the socket counterclockwise until the tabs on the socket align with the slots on the assembly. 3. Remove the bulb from bulb-socket by pulling it out. 4 ...
Kia Picanto JA 2017-2025 Service & Repair Manual: Power Door Mirror Switch
Components and components location Component Schematic diagrams Circuit Diagram [Folding Mirror Type] [Non-Folding Mirror Type] Repair procedures Inspection 1.Check for continuity between the terminals in each switch position according to the table. ...
