| Replacement |
| 1. | Remove the sunroof assembly.
(Refer to Sunroof - "Sunroof Assembly")
|
| 2. | Remove the drip rail assembly (A) after loosening the mounting screws.
|
| 3. | Separate the rear drip (A) after loosening the mounting screws.
|
| 4. | Remove the stopper (A) by pushing it in the direction of the arrow.
|
| 5. | Remove the sunroof sunshade (A) by pushing it backward.
|
| 6. | Install in the reverse order of removal.
|
Components and components location Components 1. Sunroof assembly Repair procedures Replacement • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
Repair procedures Replacement 1.Remove the sunroof assembly. (Refer to Sunroof - "Sunroof Assembly") 2.Remove the sunroof sunshade.
Repair procedures Inspection Multifunction Switch Inspection 1. Check for continuity between the terminals in each switch position as shown below. Rear Wiper & Washer Switch[LHD] [RHD] Inspection (With KDS/GDS) 1. In the body electrical system, failure can be quickly diagnosed by using the vehicle diagnostic system (KDS/GDS).
Components and components location Component Location 1. Mode Control Actuator Description and operation Description The mode control actuator is located at the heater unit. It adjusts position of mode door by operating mode control actuator based on signal of A/C control unit.