Other information:
Repair procedures
Inspection
1.Disconnect the negative (-) battery terminal.
2.Remove the roof trim assembly.
(Refer to Body - "Roof Trim Assembly")
3.Remove the glass motor (A) after loosening the mounting screws.
4.Ground the terminals as below table, and check t ...
Schematic diagrams
ECM Terminal and Input/Output signal [M/T]
1. Harness Connector
2. Terminal Function [M/T]
[Connector A]
Pin No
Description
1 Ignition coil (Cylinder #3) control output 2 Ignition coil (Cylinder ...