Kia Picanto: If you have a flat tire (with tire mobility kit) (Type A) / Distributing the sealant
13. Immediately drive approximately
7~10 km (4~6 miles or, about 10
min) to evenly distribute the sealant
in the tire.
CAUTION
Do not exceed a speed of 60 km/h
(35 miles). If possible, do not fall below
a speed of 20 km/h (12 miles).
While driving, if you experience any
unusual vibration, ride disturbance
or noise, reduce your speed and
drive with caution until you can
safely pull off of the side of the
road. Call for road side service or
towing.
When you use the Tire Mobility Kit,
the wheel may be stained by sealant.
When you use the Tire Mobility
Kit, the wheel may be stained by
sealant. Therefore, remove the
wheel stained by sealant and have
the vehicle inspected at a professional
workshop. Kia recommends to
visit an authorized Kia dealer/service
partner.
1. Detach the speed restriction label
(1) from the sealant bottle (2), and
place it in a highly visible place inside
the vehicle such as on the
steering wheel to remind the driver
not to dri ...
1. After driving approximately
7~10 km (4~6 miles or about 10 minutes),
stop at a suitable location.
2. Connect the filling hose (3) of the
compressor (clip mounted side) directly
and then co ...
Other information:
1. After driving approximately
7~10 km (4~6 miles or about 10 minutes),
stop at a suitable location.
2. Connect the filling hose (3) of the
compressor (clip mounted side) directly
and then connect the filling
hose (3) (opposite side) to the tire
valve.
3. Connect between compressor and ...
Components and components location
Components
1. Manifold absolute pressure sensor (MAPS) 2. Intake manifold 3. Electronic throttle body control (ETC) module gasket 4. Intake manifold gasket 5. Positive crankcase ventilation (PCV) hose 6. Vacuum hose & pipe
Repair procedures
...