Kia Picanto: If you have a flat tire (with tire mobility kit) (Type A) / Checking the tire inflation pressure
1. After driving approximately 7~10 km (4~6 miles or about 10 minutes), stop at a suitable location.
2. Connect the filling hose (3) of the compressor (clip mounted side) directly and then connect the filling hose (3) (opposite side) to the tire valve.
3. Connect between compressor and the vehicle battery using the cable and connectors.
4. Adjust the tire inflation pressure to 230 kPa (33 psi. With the ignition switched on, proceed as follows.
- To increase the inflation pressure: Switch on the compressor, position I. To check the current inflation pressure setting, briefly switch off the compressor.
WARNING
Do not let the compressor run for more than 10 minutes, otherwise the device will overheat and may be damaged.
- To decrease the inflation pressure: Press the button (9) on the compressor.
CAUTION
If the inflation pressure is not maintained, drive the vehicle a second time, refer to Distributing the sealant. Then repeat steps 1 to 4. Use of the TMK may be ineffectual for tire damage larger than approximately 4 mm (0.16 in).
Contact a professional workshop if the tire cannot be made roadworthy with the Tire Mobility Kit. Kia recommends to visit an authorized Kia dealer/service partner.
WARNING
The tire inflation pressure must be at least 230 kPa (33 psi). If it is not, do not continue driving. Call for road side service or towing.
Distributing the sealant
13. Immediately drive approximately
7~10 km (4~6 miles or, about 10
min) to evenly distribute the sealant
in the tire.
CAUTION
Do not exceed a speed of 60 km/h
(35 miles). If possible, do no ...
Notes on the safe use of the
Tire Mobility Kit
Park your car at the side of the road
so that you can work with the TMK
away from moving traffic. Place your
warning triangle in a prominent place
to make passing vehicles aware of
y ...
Other information:
Kia Picanto JA 2017-2025 Service & Repair Manual: Rear Glass Defogger Printed Heater
Repair procedures Inspection • Wrap tin foil around the end of the voltmeter test lead to prevent damaging the heater line. Apply pressure on the tin foil with hand and move the tin foil along the grid line to check for open circuits. ...
Kia Picanto JA 2017-2025 Owner's Manual: In case of an emergency while driving
If the engine stalls at a crossroad or crossing If the engine stalls at a crossroad or crossing, set the shift lever in the N (Neutral) position and then push the vehicle to a safe place. If your vehicle has a manual transaxle not equipped with a ignition lock switch, the vehi ...
