Kia Picanto (JA): Body Side Molding / Front Wheel Guard

Repair procedures

Replacement
   
Put on gloves to protect your hands.
   
Use a plastic panel removal tool to remove interior trim pieces without marring the surface.
Be careful not to bend or scratch the trim and panels.
1.
Remove the front tire.
2.
Remove the front wheel guard (A), after loosening the mounting clips and nuts.

3.
Install in the reverse order of removal.
   
Replace any damaged clips.

    Repair procedures Replacement    Put on gloves to protect your hands.    • Use a plastic panel removal tool to remove interior trim pieces without marring the surface.

    Repair procedures Replacement    Put on gloves to protect your hands.    • Use a plastic panel removal tool to remove interior trim pieces without marring the surface.

    Other information:

    Kia Picanto (JA) 2017-2025 Service & Repair Manual: Headlamp Leveling Switch

    Schematic diagrams Circuit Diagram Repair procedures Removal 1.Disconnect the negative (-) battery terminal. 2.Remove the crash pad lower panel. (Refer to Body - "Crash Pad Lower Panel") 3.Remove the crash pad side switch (A) after loosening the mounting screws.

    Kia Picanto (JA) 2017-2025 Service & Repair Manual: Rear Washer Switch

    Repair procedures Inspection Multifunction Switch Inspection 1. Check for continuity between the terminals in each switch position as shown below. Rear Wiper & Washer Switch[LHD] [RHD] Inspection (With KDS/GDS) 1. In the body electrical system, failure can be quickly diagnosed by using the vehicle diagnostic system (KDS/GDS).

    Categories

     
    Copyright © 2025 www.kpicanto.com - 0.0165