Kia Picanto: Lighting / High beam operation
To turn on the high beam headlights, push the lever away from you when the headlight is on. Pull it back for low beams.
The high beam indicator will light when the headlight high beams are switched on. To prevent the battery from being discharged, do not leave the lights on for a prolonged time while the engine is not running.
WARNING
Do not use high beam when there are other vehicles. Using high beam could obstruct the other driver's vision.
To flash the headlights, pull the lever towards you. It will return to the normal (low beam) position when released. The headlight switch does not need to be on to use this flashing feature.
Lighting control
The light switch has a Headlight and a
Parking light position.
To operate the lights, turn the knob at
the end of the control lever to one of
the following positions:
1. Off position
2. Aut ...
Turn signals and lane change
signals
The ignition switch must be on for the
turn signals to function. To turn on the
turn signals, move the lever up or down
(A).
The green arrow indicators on the instrument
panel indicate whic ...
Other information:
Kia Picanto JA 2017-2025 Service & Repair Manual: Power Door Mirror Switch
Components and components location Component Schematic diagrams Circuit Diagram [Folding Mirror Type] [Non-Folding Mirror Type] Repair procedures Inspection 1.Check for continuity between the terminals in each switch position according to the table. ...
Kia Picanto JA 2017-2025 Service & Repair Manual: Front Driveshaft
Components and components location Components 1. Drive shasft (LH) 2. Drive shaft (RH) [RH] 1. BJ assembly 2. Clip 3. BJ boot band 4. BJ boot 5. Dynamic damper band 6. Dynamic damper 7. Shaft 8. TJ boot band 9. TJ boot 10. Spider assembly 11. Circlip 12. TJ housing 13. Circlip ...
Copyright © www.kpicanto.com 2017-2025
