Kia Picanto: Towing / Emergency towing
f towing is necessary, we recommend
you to have it done by an authorized
Kia dealer or a commercial tow truck
service.
If towing service is not available in an
emergency, your vehicle may be temporarily
towed using a cable or chain
secured to the emergency towing hook
under the front (or rear) of the vehicle.
Use extreme caution when towing the
vehicle. A driver must be in the vehicle
to steer it and operate the brakes.
Towing in this manner may be done only
on hard-surfaced roads for a short
distance and at low speed. Also, the
wheels, axles, power train, steering and
brakes must all be in good condition.
- Do not use the tow hooks to pull a
vehicle out of mud, sand or other
conditions from which the vehicle
cannot be driven out under its own
power.
- Avoid towing a vehicle heavier than
the vehicle doing the towing.
- The drivers of both vehicles should
communicate with each other frequently.
CAUTION
- Attach a towing strap to the tow
hook.
- Using a portion of the vehicle
other than the tow hooks for
towing may damage the body of
your vehicle.
- Use only a cable or chain specifically
intended for use in towing
vehicles. Securely fasten the cable
or chain to the towing hook
provided.
- Before emergency towing, check if
the hook is not broken or damaged.
- Fasten the towing cable or chain securely
to the hook.
- Do not jerk the hook. Apply it steadily
and with even force.
- To avoid damaging the hook, do not
pull from the side or at a vertical angle.
Always pull straight ahead.
WARNING
Use extreme caution when towing
the vehicle.
- Avoid sudden starts or erratic driving
maneuvers which would place
excessive stress on the emergency
towing hook and towing cable or
chain. The hook and towing cable
or chain may break and cause serious
injury or damage.
- If the disabled vehicle is unable to
be moved, do not forcibly continue
the towing. We recommend that
you contact an authorized Kia
dealer or a commercial tow truck
service for assistance.
- Tow the vehicle as straight ahead
as possible.
- Keep away from the vehicle during
towing.
- Use a towing strap less than 5 m
(16 feet) long. Attach a white or red
cloth (about 30 cm (12 inches) wide)
in the middle of the strap for easy
visibility.
- Drive carefully so that the towing
strap is not loosened during towing.
Emergency towing precautions
- Turn the ignition switch to ACC so the
steering wheel isn’t locked.
- Place the transaxle shift lever in N
(Neutral).
- Release the parking bake.
- Press the brake pedal with more
force than normal since you will have
reduced brake performance.
- More steering effort will be required
because the power steering system
will be disabled.
- If you are driving down a long hill, the
brakes may overheat and brake performance
will be reduced. Stop often
and let the brakes cool off.
CAUTION
Automatic transaxle
- If the car is being towed with all
four wheels on the ground, it can
be towed only from the front. Be
sure that the transaxle is in neutral.
Be sure the steering is unlocked
by placing the ignition
switch in the ACC position. A driver
must be in the towed vehicle to
operate the steering and brakes.
- To avoid serious damage to the
automatic transaxle, limit the vehicle
speed to 15 km/h (10 mph)
and drive less than 1.5 km (1 mile)
when towing.
- Before towing, check the automatic
transaxle for fluid leaks under
your vehicle. If the automatic
transaxle fluid is leaking, flatbed
equipment or a towing dolly must
be used.
1. Open the tailgate, and remove the
towing hook from the tool case.
2. Remove the hole cover pressing the
upper (front) part of the cover on
the bumper.
3. Install the towing hook by turnin ...
There are some emergency commodities
in the vehicle to help you respond
to the emergency situation.
Fire extinguisher
If there is small fire and you know how
to use the fire extinguisher, take ...
Other information:
Description and operation
Description
•
Side Impact Sensor (SIS) system consists of two Pressure Side Impact
Sensor (P-SIS) installed at each center of the front door module (LH and
RH), two SIS installed at each center pillar nearby (LH and RH) and two
r ...
Repair procedures
Inspection
1. Turn ignition switch OFF and disconnect the negative (-) battery terminal.
2. Remove the fuse box cover.
3. Remove the starter relay (A).
4. Check for continuity between the terminals (30 and 87) using an ohmmeter.
Terminal
...