Other information:
Repair procedures
Inspection
1.Measure terminal - to - terminal resistance of blower resistor.
2.measured resistance is not within specification, the blower resistor must be replaced. (After removing the resistor)
Replacement
1.Disconnect the negative (-) battery terminal.
2.Remove the ...
Components and components location
Components
1. Snap ring 2. Bearing 3. Axle assembly 4. Brake disc dust cover 5. Wheel hub assembly 6. Wheel brake disc 7. Brake disc fixing screw 8. Wheel / Tire 9. Wheel nut
Repair procedures
Removal
1. Remove the front/rear wheel tire (A ...