Kia Picanto: Seat Belt Pretensioner / Seat Belt Reminder

Kia Picanto JA 2017-2024 Service & Repair Manual / Restraint / Seat Belt Pretensioner / Seat Belt Reminder

Components and components location

Components

Seat Belt Reminder (SBR) Unit

1. Seat Belt Reminder (SBR) Unit

Seat Belt Reminder (SBR) Sensnor

1. Seat Belt Reminder (SBR) Sensnor

Schematic diagrams

Circuit Diaram

Repair procedures

Replacement

Seat Belt Reminder (SBR) Unit

1.	Disconnect the battery negative terminal, and wait for at least three minutes before beginning to work.

2.	Remove the glove box housing. (Refer to Body -"Glove Box Housing")

3.	Remove the seat belt reminder unit (B) after loosening the mounting nut (A).

4.	Disconnect the seat belt reminder unit connector (A)

5.	Install in the reverse order of removal.

Seat Belt Reminder (SBR) Sensnor

1.	Disconnect the battery negative terminal, and wait for at least three minutes before beginning to work.

2.	Remove the front seat assembly. (Refer to Body - "Front Seat Assembly")

3.	Remove the front seat cushion cover. (Refer to Body - "Front Seat Cushion Cover")

4.	Remove the seat belt reminder sensor (A).

5.	Install in the reverse order of removal.

Emergency Fastening Device (EFD)

Description and operation Description Driver Anchor Pretensioner operates as well as Belt Pretensioner at the same time If it gets into its deploy condition after a collision. It is locate ...

Brake System

Specifications Specifications Item Specification Master cylinder Type Single Cylinder I.D. Ø 20.64 mm (0.812 in) Piston stroke ...

Other information:

Kia Picanto JA 2017-2024 Service & Repair Manual: Alignment

Repair procedures Front wheel alignment When using a commercially available computerized wheel alignment equipment to inspect the front wheel alignment, always position the vehicle on a level surface with the front wheels facing straight ahead. Prior to inspectio ...

Kia Picanto JA 2017-2024 Service & Repair Manual: Sunroof Motor

Repair procedures Inspection 1.Disconnect the negative (-) battery terminal. 2.Remove the roof trim assembly. (Refer to Body - "Roof Trim Assembly") 3.Remove the glass motor (A) after loosening the mounting screws. 4.Ground the terminals as below table, and check t ...